High power LEDs (like all LEDs) are current driven devices. This means that the more current you provide the L...
A resistor is NOT required (nor recommended) if you are using a driver. E.g., BuckPuck, BoostPuck, PowerPuck, ...
Resistors are not recommended for regulating current to high power LEDs for two very important reasons. Fir...
BuckPuck drivers are designed to power LEDs from a voltage source that is higher than the total forward voltag...
You can calculate the input voltage that you will need using the following formula: Vt + (Vf x LEDn) = Vi...
You can calculate the number of series connected LEDs you can power with a single BuckPuck or PowerPuck driver...
No. Powering Rebel LEDs at 1050mA will exceed their maximum current rating of 1000mA. 1050mA Xitanium drivers ...
The LED should be located as close as possible to the driver. (Ideally within a few inches) If you need to mou...
We suggest that you consider the PowerPuck driver for motive power use. These drivers are fully encapsulated w...